1 Series 125i (N52K) Convertible
On replacement, assemble new part with gaiter:
•
Determine measurement (A) to simplify following adjustment
of front axle
Installation:
Slacken clamping screw (1) and screw off tie rod end.
Slide gaiter with ear clip and band clamp on tie rod.
Screw in tie rod end to measurement (A).
Tightening torque 32 21 2AZ
.
After installation:
•
Only if replacing/removing tie rod end: Perform chassis
alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Replacing (removing and installing) left or right tie rod
BMW AG - TIS
17.01.2013 09:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -