1 Series 125i (N52K) Convertible
Installing new rubber mount:
If necessary, release knurled screws 33 4 452 and pull off
mounting 33 4 455 with spring steel 33 4 456.
Insert rubber mount with spray-on points facing upwards in special
tools 33 4 451 , 33 4 452 , 33 4 454 , 33 4 453 and pull
together.
Important!
Clean rubber mount prior to drawing in and moisten with
Loctite 638.
Spray-on points of rubber mount must point to rear!
All models except M3:
Align rubber mount by way of slot (1) at an angle to rear axle
carrier.
M3:
Align rubber mount by way of slot (1) at an angle to rear axle
carrier.
RA Replacing a rubber mount for trailing arm in rear axle carrier
BMW AG - TIS
17.01.2013 09:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -