1 Series 125i (N52K) Convertible
36 10 300
Removing or installing front or rear wheel
Special tools required:
•
36 1 120
•
36 1 250
•
36 1 300
Important!
Observe safety instructions on raising the vehicle.
Follow instructions on initialising Run Flat Indicator (RPA).
After completing installation, check again that all wheel bolts
are tightened to specified torque.
Tightening torque 36 10 1AZ
.
Observe the following procedure to prevent shift errors and
imbalance:
-
Loosen wheel bolts.
-
Wheel positioned with valve facing down.
-
If several wheels are removed simultaneously, mark the
installation locations of the wheels on the tires (e.g. with
chalk).
-
Mark out wheel to wheel hub.
-
Mark out lockable wheel bolt in relation to wheel.
-
Release wheel bolts, remove wheel.
Important!
The following contact faces must be free from grease and
clean:
-
between brake disc and disc wheel
-
between brake disc and wheel hub
RA Removing or installing front or rear wheel
BMW AG - TIS
17.01.2013 10:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -