1 Series 125i (N52K) Convertible
51 47 312
Replacing footrest for front passenger
compartment
Necessary preliminary tasks:
•
Remove trim panel for pedal assembly
Note:
Footrest is either bonded to carpet or secured with retaining rings
from rear to carpet.
-
Attachments with retaining rings are drilled out
-
Bonded footrest is detached with a hot air blower
The attachment points must always be drilled out first.
Place drilling hole template (1) on footrest (2) and align to outer
edge of footrest (2) (see arrows).
Mark bore holes with punch and remove drilling hole
template (1).
Drill out attachment points.
I)
Predrill to 3 mm dia.
II)
Drill out to 10 mm dia.
Note:
If the footrest (2) is not bonded, it can be removed now. Continue
with the next work step but one.
Bonded footrest only:
Note:
Adhesive bead must remain on carpet (risk of damage).
Heat footrest (1) with hot air blower and thereby release adhesive
bead from footrest (1).
If necessary, pull off footrest (1) in inward direction.
RA Replacing footrest for front passenger compartment
BMW AG - TIS
17.01.2013 11:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -