1 Series 125i (N52K) Convertible
51 41 060
Removing and installing (replacing) armrest
on door trim panel, front left or right
Necessary preliminary tasks:
•
Remove front door handle
Important!
Risk of damage!
Only drill down to door trim panel area (2) so as not to
damage the contact surface.
Drill out welding spots (1) on door trim panel (2) with 8 mm dia.
welding spot drill bit.
Remove welding residue from door trim panel (2) and armrest
with a scalpel (for heavy-duty applications) if these components
are to be reused.
Replacement:
Saw off welding pins (1) on armrest (2) down to
measurement (A).
A= 2.0
±
0.5 mm
Installation:
Armrest:
-
position on door trim panel (1)
-
secure at front and rear with repair screw (2)
-
align until bores (3) are centrally located
-
tighten down, starting in middle
Tightening torque 51 41 2AZ
.
Note:
RA Removing and installing (replacing) armrest on door trim panel, front left or ri
BMW AG - TIS
17.01.2013 14:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -