1 Series 125i (N52K) Convertible
51 43 034
Removing and installing/replacing rear left or
right lower side trim section
Important!
Risk of damage!
When working on trim panel components, make sure that the
sensitive surfaces are not scratched or damaged.
Necessary preliminary tasks:
•
Remove rear seat
•
Release upper side trim section (do not remove)
Release screws (1).
Release retainers (2) and clips (3).
Feed lower side trim section (4) out of entrance cover strip.
Disconnect all associated plug connections and remove lower side
trim section (4) in inward direction.
Installation:
If necessary, replace faulty retainers (2) and clips (3).
Installation:
Feed in lower side trim section (1) in area of entrance cover
strip (2).
Position lower side trim section (1) correctly at retainers and clips
and clip into position.
Make sure seal (3) is correct installation position in area of belt
guide.
RA Removing and installing/replacing rear left or right lower side trim section
BMW AG - TIS
17.01.2013 14:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -