1 Series 125i (N52K) Convertible
52 13 034
Removing and installing/replacing release
mechanism on left or right front seat
(normal/manual)
Necessary preliminary tasks:
•
Remove front seat
•
Remove rear panel
Lever out trim in upward direction (1) with plastic wedge.
Slide trim forwards (2) and feed out over release handle.
Installation:
Check tabs (3) for correct seating in release mechanism.
Clip trim noticeably into place.
Front seat (electric) only:
Unfasten plug connection (1) and disconnect.
Replacement only:
Unclip switch (2).
RA Removing and installing/replacing release mechanism on left or right front seat
BMW AG - TIS
17.01.2013 17:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -