1 Series 125i (N52K) Convertible
Replacement:
•
Remove volute spring cassette
•
Carry out vehicle programming/coding
Note:
-
If replacement of the steering column switch cluster is
initiated via Progman, the steering column switch cluster
is coded indirectly via the DSC control unit
-
If coding is cancelled, first adjust the steering angle
sensor; this makes a brand-new steering column switch
cluster coding-compatible again if necessary
-
Then code the DSC control unit again
•
Carry out steering angle sensor adjustment
Note:
-
If steering angle sensor adjustment is cancelled, first
code the DSC control unit
-
Then adjust the steering angle sensor again
•
Vehicles with active front steering:
-
Steering angle sensor adjustment is performed by
means of initial operation / adjustment of active front
steering
-
If necessary, proceed in accordance with instructions
RA Removing and installing/replacing fixture for steering column stalk
BMW AG - TIS
17.01.2013 17:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -