1 Series 125i (N52K) Convertible
Release screws (1) and feed high-pressure nozzle of headlight
washer system (4) out of holder (5).
Raise retaining clip (3) in direction of arrow and detach high-
pressure line (2) from high-pressure nozzle of headlight washer
system (4).
Installation:
Keep plug connection for high-pressure nozzle (4) and high-
pressure line (2) clean and free from grease.
Make sure high-pressure line (2) is correctly engaged on high-
pressure nozzle (4).
Guide (6) of high-pressure nozzle (4) must be threaded into
associated mounting of holder (5).
Carry out a function test before fitting bumper trim.
If necessary, top up washer fluid.
Replacement:
Remove spray nozzle (nozzle head).
RA Removing and installing/replacing high-pressure nozzle (housing) of headlight wa
BMW AG - TIS
17.01.2013 17:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -