1 Series 125i (N52K) Convertible
63 25 000
Removing and installing/replacing auxiliary
brake light
Necessary preliminary tasks:
•
Remove panel for rear lid
Release nuts (1), gripping the threaded pin (2) with a suitable
tool in so doing.
Remove springs (3).
Press auxiliary brake light at threaded pin (2) outwards and
remove.
Disconnect plug connection.
Installation:
•
Make sure auxiliary brake light seal is correctly seated
•
Tighten nuts (1) from inside outwards
•
Observe tightening torque, 63 25 1AZ
RA Removing and installing/replacing auxiliary brake light
BMW AG - TIS
17.01.2013 18:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -