1 Series 128i (N52K) Convertible
Important!
Guide spring struts with your hand when lowering and raising
in order to avoid damaging the wheel arches.
After lowering, the spring struts must be aligned to the front
axle carrier and secured in such a way that the ball joints of
the control arms, tension struts and tie rod ends are not
damaged.
Remove both spring struts from spring strut dome.
Lower front axle carrier
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Removing and installing complete front axle (with spring struts)
BMW AG - TIS
18.01.2013 04:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -