1 Series 128i (N52K) Convertible
51 11 156
Removing and installing/replacing front
bumper trim
Special tools required:
•
00 9 317
Release screws (1) on bumper trim (2).
Tightening torque 51 11 1AZ
.
Lift bumper trim (2) over guide (3).
If necessary, release seal (4) on bumper trim (2).
Release screws (1) on wheel arch trim (2) on left/right.
Lift out wheel arch trim (2) at side.
Installation:
Make sure wheel arch trim (2) is in correct position.
Release screws (1) on bumper trim (2).
RA Removing and installing/replacing front bumper trim
BMW AG - TIS
18.01.2013 06:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
