1 Series 128i (N52K) Convertible
51 43 201
Removing and installing or replacing trim for
roof pillar at front (A-pillar), left or right
Important!
Risk of damage!
When working on trim panel components, make sure that the
sensitive surfaces are not scratched or damaged.
Release trim (1) inwards from clips (2) and feed out from
instrument panel.
Installation:
Make sure mucket (3) is correctly seated on trim (2).
Installation:
If necessary, lever out clips (1) remaining in bores.
If necessary, replace faulty clips (1).
Make sure guides (3) are correctly seated in associated
mountings.
Guides (3) must not be damaged.
Position trim for front roof pillar (2) preinstalled with clips (1) on
associated bores and clip into place.
RA Removing and installing or replacing trim for roof pillar at front (A-pillar), l
BMW AG - TIS
18.01.2013 07:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -