1 Series 128i (N52K) Convertible
54 34 005
Removing and installing/replacing hydraulic
control unit for convertible top drive
Necessary preliminary tasks:
•
Remove right wheel arch trim
Caution!
Hydraulic fluid may emerge from the disconnected lines and
the open connections on the hydraulic control unit.
Protect components and work area with suitable materials
(e.g. cloths).
Make sure that dirt cannot get into the hydraulic circuit.
Follow repair instructions for hydraulic system.
Do not fit hydraulic lines in kinked, crushed or transposed
condition.
Unlock plug connections (1) and disconnect.
Disengage rubber tensioner (2).
Remove hydraulic control unit from side box.
Release screws (1) on retaining plate (2).
Detach hydraulic lines.
Installation:
Hydraulic lines and connections are marked with numbers to
prevent mix-ups.
Check fluid level or top up if necessary.
Fully open and close convertible top a minimum of 10 times in
order to bleed the hydraulic system.
RA Removing and installing/replacing hydraulic control unit for convertible top dri
BMW AG - TIS
18.01.2013 07:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
