1 Series 128i (N52K) Convertible
72 11 030
Removing and installing or replacing front
seat belt
Necessary preliminary tasks:
•
Remove rear side trim panel
Note:
If a seat belt which is damaged due to an accident is
exchanged, check the slide bar for damage (bending) and
replace if necessary.
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 minutes (start
of curing)
•
Microencapsulated screws must not be retightened
•
Clean thread of nut beforehand in event of repeated use
Lever out cap (1).
Release screw (2).
Tightening torque: 72 11 05AZ
.
Installation:
Check that spacer bushing (3) and rubber ring (4) are in correct
position.
Unclip trim (1) for belt deflector with a plastic wedge.
RA Removing and installing or replacing front seat belt
BMW AG - TIS
18.01.2013 09:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
