1 Series 128i (N52K) Convertible
72 12 006
Removing and installing/replacing knee
airbag module for front passenger protection
Warning!
Read and comply with safety regulations for handling airbag
modules and pyrotechnical belt pretensioners.
Incorrect handling can activate airbag and cause injury.
Installation:
•
Microencapsulated screws (Loctite) must be replaced and
may not be reused
•
Screw connection must be completed within 20 minutes (start
of curing)
•
Microencapsulated screws must not be retightened
•
Clean thread of nut beforehand in event of repeated use
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Open glovebox.
Release screws (1).
Tightening torque: 72 12 08AZ
.
Close glovebox.
RA Removing and installing/replacing knee airbag module for front passenger protect
BMW AG - TIS
18.01.2013 09:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
