3 Series E30 320i (M20) TOUR
5)
Outer disc
6)
Inner disc
7)
Compression ring
8)
Differential side gear
9)
Final drive gears with differential shafts
10) Final drive housing
Check all parts for wear,
e.g. molybdenum coating, gears.
Installation:
Lubricate all parts with approved final drive oil before
assembling.
Install following parts in correct installed order to measure the
preload:
Outer plates (5), inner plates (6), thrust rings (7), differential side
gears (8) and differential gears with differential shafts (9).
Measure dimension A from edge of housing to outer disc, e.g. A =
10.8 mm.
Measure dimension B on cover, e.g. B = 6.8 mm.
Place both diaphragm spring curved surfaces together.
Measure dimension C on the plate springs, e.g. C = 3.6 mm.
RA Dismantling and assembling limited slip differential (Type K) - final drive remo
BMW AG - TIS
22.01.2013 19:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
