3 Series E30 320i (M20) TOUR
Installation:
Install diaphragm spring (2) with inside curved surface facing
up and thrust washer (3) with oil pockets facing up in case
cover, using grease.
Installation:
Mount case cover with washers (being careful that washers
do not slide out).
Install bolts with Loctite No. 270 and tighten cover uniformly.
Tightening torque, refer to Technical Data
Check slip torque of limited slip differential, refer to Technical
Data,
with one secured rear wheel and one driven rear wheel.
Make up tool locally for this purpose by, for example, welding a nut
on a drive flange which is no longer required.
RA Dismantling and assembling limited slip differential (Type K) - final drive remo
BMW AG - TIS
22.01.2013 19:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -