3 Series E30 324td (M21) SAL
C actual
- 11,50 mm
a
0,20 mm
Master disc A
3,90 mm
- a
0,20 mm
Thickness of shim (X)
4,10 mm
If C Nominal is less than C Actual, "a" on the shim ring (x) is
added to the value.
The permitted tolerance for dimension (x) is derived from the gage
steps available for shim rings (0.01 ... 0.03 mm)
Remove drive pinion and rear bearing outer race.
Press in shim (X) of determined thickness and bearing outer race.
Caution!
Do not install the drive pinion at this point, since it is first
necessary to measure and adjust the friction torque of the
new final drive housing bearing.
Press pulse spider (3) off of final drive housing.
Caution!
Don't bend the pulse spider.
RA Replacing input bevel gear and crown wheel (Type M) - final drive housing remove
BMW AG - TIS
24.01.2013 12:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -