3 Series E30 324td (M21) SAL
Caution!
Once nut (1) of pull rod (2) has been released, do not move
handbrake lever. Handbrake lever can flick upwards.
Release screw (1) on pull rod (2) and remove hexagon nut. Slide
brake compensator (3) towards rear.
Installation:
Use new self-locking nut.
Release screws (1) on jockey wheel mount and remove.
Release wiring harness mount (2) and remove. Reinstall screw
and tighten until hand-tight.
Installation:
Tightening Torque for jockey wheel mount (1),
refer to Technical Data 86 10 11AZ.
Tightening Torque for wiring harness mount (2),
refer to Technical Data 86 10 12AZ.
Release screw on socket holder (1) and remove. Cut through
strap (2) and lay wiring harness to one side. Pull gaiter (3) in
direction of arrow.
Installation:
Use new self-locking nut.
Tightening Torque,
refer to Technical Data 86 10 13AZ.
RA Removing overrunning equipment/maintaining or replacing guide bush/installing ov
BMW AG - TIS
24.01.2013 13:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -