3 Series E36 316i (M43) SAL
If necessary, remove oil wiper.
If necessary, remove intake snorkel for oil pump.
Installation:
The intake snorkel is secured with self-tapping screws. For
this reason, no threading is present on new oil pans. Thread
can be shaped using existing screws.
Replace seal for intake snorkel.
Version up to 9/95 (flat seal)
Installation:
Sealing faces clean and free of seal debris.
Coat contact edges of separating face with Drei Bond 1209
(refer to BMW Parts Service).
Replace seal.
Version from 9/95 (profile seal)
Installation:
Sealing faces clean and free of seal debris.
Replace the oil pan seal.
Fill openings in oil pan seal above joints to end cover and to
gear case with Drei Bond 1209 (refer to BMW Parts
Service).
Installation:
Insert all screws in oil pan.
Insert but do not yet tighten oil pan screws, on transmission
end.
Tighten down screws on engine end.
Tighten screws on transmission end.
RA Removing and installing, sealing or replacing oil pan (M43 / M43TU)
BMW AG - TIS
20.01.2013 03:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -