3 Series E36 316i (M43) SAL
11 21 500
Replacing crankshaft (M43 / M43TU)
(engine removed)
Remove timing case at bottom.
M43TU only:
Remove balancing shaft housing with balancing shafts.
Remove pistons.
Remove flywheel.
Remove end cover at rear. This task is described in the section
Replacing crankshaft radial seal.
Remove screws securing main bearing caps.
Remove main bearing caps 1 to 5.
Lever out crankshaft.
If necessary, release incremental gear.
Installation:
Replace screws.
Install screws and tighten down in two passes.
Tightening torque 11 21 1AZ.
RA Replacing crankshaft (M43 / M43TU)
BMW AG - TIS
20.01.2013 03:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -