3 Series E36 316i (M43) SAL
Insert locking lever (1) with long tongue (2) into slot of 5th/reverse
gear shift arm.
Swivel locking lever (1) inwards and in so doing engage in
recesses of 1st/2nd and 3rd/4th gear shift arms.
Center locking lever (1) by hand with bores.
Install bearing pins (2) and (3) on left and right and tighten down.
Tightening torque, 23 31 1AZ.
Carry out movement check on locking lever.
Insert selector shaft (4) in horizontal position.
Apply grease to 4 rollers.
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
20.01.2013 05:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 12 -