3 Series E36 316i (M43) SAL
Drive bearing (2) firmly home - lettering upwards - into bearing
bush (1) with special tool 32 1 140 /240 /250.
Slide bearing bush (1) - radial shaft seal outermost - onto the
steering spindle.
Grease rack and pinion,
refer to BMW Service Operating Fluids.
Pull out rack to recorded dimension (A).
Carefully insert steering spindle into case and install retaining ring.
Check that marks are aligned.
Push on protective cap in this position, whereby marking of
housing, steering spindle and protective cap must align.
RA Dismantling and reassembling power steering gear
BMW AG - TIS
20.01.2013 05:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -