3 Series E36 316i (M43) SAL
Installation:
Clean tapped bores thoroughly (tapper).
Heat plate spring to max. 100
°
C (thermo-chrome pin).
Mount crown wheel with two locally manufactured staybolts for
guiding.
Install new bolts with Loctite No. 270. Tighten bolts in order of
1 ... 10.
Tightening torque and torsion angle,
refer to Technical Data
Install new limited slip differential with crown wheel and pulse
sender.
Install marked side bearing covers with corresponding washers
and new O-rings.
Tighten bearing cover screws evenly.
Tightening torque, refer to Technical Data
RA Replacing complete locking differential (Type M) - final drive removed -
BMW AG - TIS
20.01.2013 06:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -