3 Series E36 316i (M43) SAL
Examine adjoining adhesive flanges for peeling off. If necessary, seal and preserve with sealing compound.
Observe the frame alignment control dimensions for the support carrier.
Any repairs to the bulkhead if cracked outside the approved repair scopes are only permitted after consultation
with and approval by BMW. Should you have any questions, please contact the country-specific Hotline.
-
Reshaping of extruded sections and cast parts may only be used to achieve optimum joining of connecting faces
(e.g. when bulkhead is damaged). Reshaped parts must be replaced.
-
Repairs which affect the mounting points of mechanical assemblies and chassis components must be carried out
on the straightening bench. Use the vehicle-specific straightening attachment set or vehicle-specific data sheet.
Straightening attachment supports and data sheets are also available for the top section, e.g.: door pillars,
convertible top mounts, cowl, rear lid hinges, etc.
-
Check windshield and rear window apertures for curvature by inserting the original glass.
-
Take the gap dimensions for doors, engine hood and rear lid from the vehicle-specific gap dimension diagram.
RA Straightening aluminium parts
BMW AG - TIS
20.01.2013 07:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -