3 Series E36 318i (M42) CONVER
Installation note:
When replacing a side member, the holes must be drilled prior
to painting.
Align the drilling hole template to equal distance at front and
rear edge and paste along the edge.
Punch mark centers, drill 9 mm dia. holes, deburr and coat
edges of holes with zinc dust paint.
Pull off drilling hole template.
Install new grommets and clips in side member.
Clip on and align trim panel, and mark locations of 5.0 mm dia.
holes at rear.
Mark locations of 6.5 mm dia. holes at bottom.
Unclip trim panel.
Lift out and place clips in a water bath.
Punch mark centers, drill holes, deburr and coat edges of holes
with zinc dust paint.
RA Removing and installing or replacing panel for cover on left or right side membe
BMW AG - TIS
22.01.2013 17:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -