3 Series E36 318i (M44) SAL
Remove Bowden cable for throttle actuation from throttle.
Remove suction filter housing.
Remove fan clutch with fan impeller.
Remove radiator.
Disconnect heater hoses at heater and heating valve.
Release oil tank for hydraulic steering and tie back to one side.
Note:
Lines remain connected.
Unfasten vane pump for power steering unit from alternator carrier
and tie up to one side (lines remain connected).
Remove manifold lower section.
Unfasten the wire harness section for the engine.
The plug and screw connections are described in the work step
Replacing wiring harness section for engine.
RA Removing and installing engine (M44)
BMW AG - TIS
27.01.2013 02:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
