bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

ABOUT US
3 RA Removing And Installing, Sealing Or Replacing Timing Case (M44) > < 2 RA Removing And Installing, Sealing Or Replacing Timing Case Cover At Bottom (M44)

3 Series E36 318i (M44) SAL

Page 2
background image

Installation:

To fasten the seals, insert special tool 11 4 110.

Replace seal.

Coat the seal on the front and rear ends thinly with
Drei Bond 1209, refer to BMW Parts Service.

Installation:

Install timing case cover, insert all screws and initially tighten
to approx. 5 Nm. 

Fully tighten all screws in alternate sequence.

Tightening torque,

refer to Technical Data 11 14 1AZ.

Caution!

If all screws are tightened, they must be tightened again in a
second operation.

Replace radial seal,

refer to 11 14 141.

RA  Removing and installing, sealing or replacing timing case cover at bottom (M44)

BMW AG - TIS

27.01.2013  02:25

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

3 RA Removing And Installing, Sealing Or Replacing Timing Case (M44) > < 2 RA Removing And Installing, Sealing Or Replacing Timing Case Cover At Bottom (M44)