3 Series E36 318i (M44) SAL
62 16 071
Removing and installing or speedometer-
display sensor
Disconnect plug-in connection at rear axle.
Unfasten screws (1) and remove speedometer-display sensor.
Installation note:
Replace O-ring and coat with HLS-90 oil. Slide O-ring onto
speedometer-sensor shaft as far as slip phase (A).
Install sensor with O-ring in rear axle and tighten both screws
uniformly.
RA Removing and installing or speedometer-display sensor
BMW AG - TIS
27.01.2013 10:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -