3 Series E36 318is (M44) COUPE
Installation:
Apply a thin coating of grease to top side of rubber profile
gasket and both sides of special tool 11 2 330 and place
special tool on gasket.
Installation:
Fit gear case cover. Insert screws and fit flush.
Carefully pull out special tool 11 2 330.
Remove the sealing ring for the oil feed of the spray lead.
Installation:
Check/replace sealing ring. Preassemble the sealing ring to
the oil feed.
Installation:
Install cylinder head cover without seal.
Install M 6 screws with large washers and press gear case
cover down until upper edge of gear case cover and cylinder
head are aligned.
RA Removing and installing, sealing or replacing timing case cover at top (M44)
BMW AG - TIS
05.02.2013 04:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -