3 Series E36 318is (M44) COUPE
Version with manual actuation:
Mount winder on removed transmission and turn clockwise or
counterclockwise until locking in transmission becomes apparent
(neutral position).
Installation:
Install adjusting levers on left/right to lid of slide/tilt sun roof.
Retaining pin (1) must locate correctly in bore (2).
Replace screws (1) (microencapsulation) or refit old screws with
Loctite 270 (Sourcing Reference: BMW Parts Service).
Pull up adjusting lever and tighten screws (1) firmly down.
Do not tighten down!
Only on version with carriage without retaining spring:
Unscrew retaining screw (2) left/right until assembly aperture is
open.
Coat protruding thread with Loctite 270 (Sourcing Reference:
BMW Parts Service).
Note:
Hardening of Loctite 270 takes about 30 minutes.
Install slide/tilt sun roof lid, ensuring that adjusting levers (1) locate
correctly at front left/right sides in carriage (2).
RA Removing and installing lid on slide/tilt sun roof
BMW AG - TIS
05.02.2013 13:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -