3 Series E36 318is (M44) SAL
12 14 525
Replacing sensor for cylinder identification
(M44)
Switch off ignition
Removing top section of manifold,
refer to 11 61 040
Unfasten screw
Installation:
Check gasket and replace if necessary.
Unfasten screw (1) and remove cable holder.
Unfasten plug connection (1).
Installation:
Interrogate fault memory of DME-control unit, check faults in
memory then cancel fault memory.
RA Replacing sensor for cylinder identification (M44)
BMW AG - TIS
06.02.2013 17:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
