3 Series E36 318tds (M41) SAL
Unfasten timing case cover.
Installation:
Remember to fit hollow bush.
Installation:
Replace seal.
Seals for timing-chain cover and oil pump can only be
obtained as a paired set.
When repairing timing-chain cover, detach seal at marked
points.
Installation:
Install timing case cover, insert all screws and initially tighten
to approx. 5 Nm.
Fully tighten all screws in alternate sequence.
Tightening torque,
refer to Technical Data 11 14 1AZ.
Caution!
If all screws are tightened, they must be tightened again in a
second operation.
RA Removing and installing, sealing/replacing timing case cover at bottom (M41)
BMW AG - TIS
06.02.2013 20:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
