3 Series E36 318tds (M41) SAL
Tightening specifications for main bearing:
1.
Tighten all screws in main bearing cover to jointing torque.
2.
Unfasten screws in main bearing cover 4.
3.
Strike front and back of crankshaft with plastic hammer to
centre the pilot bearing (do not damage crankshaft).
4.
Tighten screw on main bearing cover 4 to jointing torque.
5.
Tighten all screws in main bearing cover with special tool
11 2 110 or special tool 00 9 120 with torsion angle.
Tightening torque,
refer to Technical Data 11 11 1AZ
Check axial play.
End float,
refer to Technical Data
Replacing conrod bearing shells,
refer to 11 24 571
Replacing grooved ball bearing in crankshaft,
refer to 11 21 571
RA Replacing crankshaft (M41)
BMW AG - TIS
06.02.2013 20:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
