3 Series E36 318tds (M41) SAL
11 25 671
Replace piston rings on all pistons (M41)
(pistons removed)
Remove piston rings with piston ring compressing pliers.
Note:
It might not be possible to find the identification mark on used
piston rings.
Lay piston rings aside in correct sequence and installed
position.
Installation note:
Install piston rings with the word "TOP" facing the piston base.
1.
Twin-sided keystone
2.
Taper face compression ring
3.
Beveled roof ring with rubber-lined spring
Arrange piston ring contact points with offset of about 120
°
but do
not arrange over piston pin aperture.
Measure face runout.
Face runout,
refer to Technical Data
RA Replace piston rings on all pistons (M41)
BMW AG - TIS
06.02.2013 20:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -