3 Series E36 318tds (M41) SAL
Unscrew bolts.
Remove cover.
Take wiring-harness grommet out of cover.
Remove relays for glow pins (2).
Push locking hook back and pull control unit out.
Disconnect connector.
Check 80 amp fuse.
Replace fuse if faulty. Unscrew screws.
Installation note:
For tightening torque, refer to Technical Data 12 21 2AZ
Note:
If melt insert has burnt through, always check to find cause of
fault.
If applicable, check glow plugs, refer to 12 23 000
RA Removing and installing or replacing relays for glow plugs (M41)
BMW AG - TIS
06.02.2013 21:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -