3 Series E36 318ti (M44) COMP
Installation:
When installing cylinder head cover, make sure that cylinder
head cover seal is correctly seated on rear side of cylinder
head.
Install cover bolts and align cylinder head cover. Hand-tighten
all cover bolts without preload. Tighten cap screws crosswise
from inside to outside.
Tightening torque,
refer to Technical Data 11 12 11AZ
RA Removing and installing/sealing cylinder head cover (M44)
BMW AG - TIS
06.02.2013 20:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -