3 Series E36 318ti (M44) COMP
Installation:
Check/replace sealing ring.
Unscrew oil sump.
If necessary, remove oil wiper.
If necessary, remove intake snorkel for oil pump.
Installation:
The intake snorkel is secured with self-tapping screws. For this
reason, no threading is present on new oil sumps. Thread can be
shaped using existing screws.
Replace seal for intake snorkel.
Installation:
Sealing faces clean and free of seal debris.
Replace the oil sump gasket.
Fill openings in oil sump gasket through parting lines to sealing
cover and to timing case with Drei Bond 1209 (refer
to BMW Parts Service).
Installation:
To prevent any possibility of torsion stress when transmission is
fitted, align oil sump on transmission end with engine block.
RA Removing and installing, sealing or replacing oil sump - engine removed (M44)
BMW AG - TIS
06.02.2013 21:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
