3 Series E36 320i (M52) CONVER
M50/ M52 engine:
Remove heater bulkhead.
Unscrew injection pipe cover (1). Screw special tool 11 0 030
down through intake manifold and into bracket of crankcase.
Install special tool 00 0 200 and attach to special tool
11 0 030 .
Tighten spindle (2).
Engine M51:
Remove cover from manifold.
Secure special tool 11 2 370 on intake pipe, rear.
Install special tool 00 0 200 and attach to special tool
11 2 370 .
Tighten spindle.
S50 engine:
Suspend special tool 11 8 022 from left and right control arms.
Important!
Position special tool so that engine oil sump rests securely on
special tool.
Tighten down knurled screws until special tool fits tightly with
engine oil sump.
Support transmission with a workshop hoist.
Unfasten screws and remove cross member with rubber mount.
Tightening torque, 23 71 1AZ/2AZ.
Lower workshop hoist.
RA Removing and installing transmission (S5D 260Z, S5D 310Z)
BMW AG - TIS
07.02.2013 00:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -