3 Series E36 320i (M52) CONVER
Installation:
Replace stop nuts.
Only tighten screw connection by way of nut.
To prevent subjecting flexible disk to torsion stress, turn
nuts/screws on flange side.
Remove constant-velocity joint from final drive.
Remove center bearing.
Tightening torque, 26 11 6AZ.
Installation:
Pretension center bearing in direction of travel 2 ... 4 mm (A).
Caution!
Do not let propeller shaft fall into joints. In particular, on constant-
velocity joint, rubber collar can become squashed, or joints may
be damaged.
RA Removing and installing propeller shaft - version with rear constant-velocity jo
BMW AG - TIS
07.02.2013 01:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -