3 Series E36 320i (M52) CONVER
31 11 001
Replacing front axle support
Caution!
After installation, align front axle,
refer to 32 00 610.
Suspend engine in installation position with special tool.
Described in:
Removing oil sump.
Unscrew left and right bolts.
Installation:
Use washers.
Tightening Torque,
refer to Technical Data 31 12 7AZ.
Unscrew left and right nuts and knock ball joints loose with a
plastic hammer.
Installation:
Remove grease from pin and bore. Replace self-locking nut.
Force ball joint upwards using a transmission lifter and base
11 7 360; this simplifies the tightening down of the nut.
Tightening Torque,
refer to Technical Data 31 12 3AZ.
RA Replacing front axle support
BMW AG - TIS
07.02.2013 01:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -