3 Series E36 320i (M52) CONVER
34 21 200
Removing and installing/replacing both rear
disk brakes
Note:
After completing the tasks, press brake pedal several times to
the floor so that brake linings contact brake disks.
When installing new brake linings on the rear axle and
simultaneously replacing the brake linings on the front axle,
check the brake fluid level and top up to the "MAX" marking if
necessary.
Remove wheels.
Refer to 36 10 300
Lift out retaining spring (1).
Right side:
Disconnect plug connection for brake lining wear sensor.
If necessary, replace brake lining wear sensor.
Remove plastic plugs (1).
Unfasten guide screws (2) with special tool 34 1 040 and pull
brake caliper backwards to remove.
Installation:
Only clean guide screws; do not grease.
Check threads.
Replace all guide screws which are not in perfect condition.
Tightening torque,
refer to Technical Data 34 21 5AZ .
RA Removing and installing/replacing both rear disk brakes
BMW AG - TIS
07.02.2013 03:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -