3 Series E36 320i (M52) CONVER
1. Basic setting
1.1 Drum brake
Note:
Fit wheels if necessary (brake drums must be fixed in place).
Tightening torque, refer to Technical Data.
Operate brake pedal until slack-control sound (soft click) is no
longer audible.
(Slack-control operation can also be observed through a wheel-
bolt bore).
1.2 Disc brake (Duo-servo handbrake)
Unscrew and remove one wheel bolt from each rear wheel.
Turn wheel until tapped bore is positioned approx. 65
°
behind a
vertical line at top (seen in forward driving direction).
Installation:
Install and tighten wheel bolt.
Tightening torque, refer to Technical Data.
Turn adjusting screw using a screwdriver until wheel or brake disk
can no longer be turned.
Left wheel is blocked in direction (a), right wheel in direction (b).
Loosen adjusting screw 18 catches (M3: 8 catches) afterwards.
RA Adjusting handbrake
BMW AG - TIS
07.02.2013 03:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -