3 Series E36 320i (M52) CONVER
54 62 500
Deploying / retracting rollover protection bar
(BMW Service Tester / MoDiC)
Requirements:
Convertible top open and hardtop not fitted.
Load the MoDiC or BMW SERVICE TESTER,
refer to BMW Diagnosis System.
Trigger:
Caution!
Risk of injury.
Trigger rollover bar by means of diagnostic unit: "controlling
component".
Note:
If the rollover bar fails to extend, it can be activated
mechanically,
refer to 54 62 001
Remove headrests,
refer to 52 20 471
Place measuring strip on protective grill.
Press rollover bar down by hand against the pawl detent.
Read off extension height on the marks on the left side of both
rollover bars.
Caution!
Extension height must be 0
±
3 mm.
If this value lies outside the tolerance, the rollover protection
system (rollover bars) must be replaced.
RA Deploying / retracting rollover protection bar (BMW Service Tester / MoDiC)
BMW AG - TIS
07.02.2013 06:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -