3 Series E36 323i (M52) CONVER
Turn the eccentric shaft to pre-tension the bearing caps.
Unfasten nuts on bearing cover.
Remove tension from the eccentric shaft and remove special tool
11 3 260.
Remove bearing covers and place to one side in orderly fashion.
Remove camshaft.
If necessary, remove complete bearing strip with bucket tappets.
Brace bucket tappets with special tool 11 3 250.
Lift out complete bearing strip with bucket tappet.
Note:
Worn bucket tappets may only be reused in the same tappet
bore.
Check bearing points on bucket tappets for signs of wear
(scoring).
RA Replacing camshaft (M52/S52)
BMW AG - TIS
08.02.2013 00:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
