3 Series E36 325i (M50) CONVER
11 00 ...
Removing camshaft (M50)
Attention!
Camshafts could be pre-damaged or broken when
removal/installation were performed incorrectly without a
fixture. In addition, valves could be bent through contact
with the piston crowns when mounting the cylinder head on
the crankcase.
Always conform with procedures and sequence.
Prepare special tool 11 3 260 (fixture) for 6-cylinder engine.
Unscrew spark plugs.
Mount and bolt special-tool fixture in tapped bores for spark plugs.
Tightening torque 23 Nm
Apply pressure on bearing covers by turning the eccentric shaft.
Unscrew all bolts for bearing covers.
Installation:
Tightening torque, refer to Technical Data
RA Removing camshaft (M50)
BMW AG - TIS
08.02.2013 06:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
