3 Series E36 325i (M50) CONVER
Unscrew the filler screw plug (1).
Installation:
Check seal; replace if necessary.
Attach filler neck (2) (refer to BMW Parts) in filler opening.
Pour in ATF until it runs out.
Caution!
Only oil approved for Jatco transmissions may be used.
Run engine in selector lever setting "P" or "N". Shift transmission
in and out of all gears.
Bring ATF temperature to 30 ... 55
°
C.
Interrogate ATF temperature with MoDiC or Service Tester (refer
to Test Plan).
Check ATF level again.
Allow excess oil to escape or top up with insufficient oil.
Screw in and tighten filler plug.
Tightening torque, refer to Technical Data.
RA Removing and installing/sealing transmission sump (A5S 300J)
BMW AG - TIS
08.02.2013 09:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -