3 Series E36 325i (M50) CONVER
Installation:
Button not pressed.
Attach pin (1) of button in bore hole (2) of pull rod.
Remove clock or on-board display.
Remove panel at bottom.
Remove trim for selector lever.
Pull plug (3) on EGS switch and indicator light (4).
Installation:
Adjusting display slide of trim:
-
Press adjuster (1) of display slide (2) against stop (3).
-
Position opening of trim (4) over opening of display slide (2).
-
Move preselector lever to "N" (NORMAL) position.
-
Insert trim on preselector lever and install.
-
Move preselector lever to "P" (PARK) position.
-
Display slide (2) is now adjusted.
RA Replacing cable for gear selector lever
BMW AG - TIS
08.02.2013 10:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -