3 Series E36 325tds (M51) TOUR
18 00 020
Removing and installing complete exhaust
system (M51)
Remove the exhaust pipe from the exhaust turbocharger.
Installation:
Replace self-locking nuts.
Installation:
Check sealing ring, replacing if necessary.
Note installation position.
Installation:
Lightly coat the sealing ring and threads with copper paste
CRC, refer to BMW Parts Service.
Align the flanges parallel to each another.
Caution!
Do not apply preload to compression springs on block.
Apply preload of measurement A to the compression springs.
Tightening torque,
refer to Technical Data 18 00 1AZ
RA Removing and installing complete exhaust system (M51)
BMW AG - TIS
08.02.2013 20:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
